Step 1
Install your Retro Kit with silicone and 4 screws into your concrete sheeting or timber flooring. Be sure to use plumbing glue to connect your puddle flange to your floor waste piping.
Update your browser to view this website correctly. Update my browser now
Step 1
Install your Retro Kit with silicone and 4 screws into your concrete sheeting or timber flooring. Be sure to use plumbing glue to connect your puddle flange to your floor waste piping.
Step 2
Silicone seal your edges, any holes, and the edges of your puddle flange (retro Kit). Proceed to prime your shower drain for the waterproofing paint.
Step 3
Apply your polyurethane paint to the base.
Step 4
Allow to cure overnight. Once completely dried, place your test plug into the drain hole and fill shower base with water. Once it is confirmed the waterproofing membrane in leak proof, drain the water and proceed to step 5
Step 5
Remove the test plug and insert your base with the cap on. Start adding your bedding mix to the base.
Step 6
Measure out your bedding and start creating your pre-slope.
Step 7
Once bedding has dried, start planning out your tile cut and measure them out. Once you know exactly where your tiles will sit you can start adding your tile glue.,
Step 8
Place tiles according and allow the glue to cure and harden overnight.
Step 9
Now apply your grout in-between your tiles and let dry overnight.
Sizes for transition from 100mm grate to
Sizes for transition from 100mm grate to